Setup?
deanne asked 9 years ago
Currently have smart connect and GP 2010 but not sure if the setup is correct. (smart connect v 20.12.0.14)
What is the proper setup? How can I test this?
(When I did a validate, nothing seemed to happen)
Answers
Best Answer
Lorren answered 9 years ago
Lorren answered 9 years ago
Deanne,
The validate button is to validate you can connect to your data source. What do you have set up as a data source.
If you choose Microsoft Dynamics GP as a destination you then choose your Dynamics GP Group and Node Type to start the mapping of the data source to the destination.
You can find the documentation at http://doc.eonesolutions.com/SmartConnect/. Then expand the Using Dynamics GP Connector section.
Thanks,
Lorren
The validate button is to validate you can connect to your data source. What do you have set up as a data source.
If you choose Microsoft Dynamics GP as a destination you then choose your Dynamics GP Group and Node Type to start the mapping of the data source to the destination.
You can find the documentation at http://doc.eonesolutions.com/SmartConnect/. Then expand the Using Dynamics GP Connector section.
Thanks,
Lorren