Map Debugging

<< Click to Display Table of Contents >>

SmartConnect 2017

Map Debugging

If a map is set to run in debug mode, SmartConnect will store debug information from each time the map is processed. The information is stored in the SmartConnect database and may be viewed through the log viewer.


Running debug logging against a map causes processing to proceed at a slower pace than running a map with no debug logging. Because of this it is advised that logging only be turned on in situations where this an issue with map processing. It can then be used to troubleshoot the issue, then once the issue has been resolved, turned off, where it will no longer affect the performance of the map.

Setting up Debug Logging
Viewing the Debug Log
Exporting / Importing Logs
Clearing Logs